Recommend installation for your GO-BIGTIME print

Make sure surface is CLEAN and DRY. For wall DO NOT USE SOAPS OR CHEMICALS OF ANY KIND. Allow wall to air dry thoroughly - about one hour. Wash vehicle as normal and wait until surface is completely dry.

Smaller Graphics

1. Peel off entire graphic from backing and place on the surface.

2. Using your hand smooth out any bubbles by pushing them to the edges. If needed you can slowly and carefully peel up the graphic to the problem area to fix. Once applied, go back over entire graphic and press down edges by hand.

Larger Graphics

1. Peel back the top 1" to 2" of the backing and fold it over.

2. Hold your graphic in place (if it's a large graphic we recommend 2 people).

3. Once in place stick the exposed 1" to 2" of the graphic to the wall smoothing it out.

4. Then reach behind and start slowly peeling the backing off while you are smoothing it on the surface with even pressure until the graphic is completely on.

5. Smooth out any bubbles by pushing them toward the edges. If needed you can slowly and carefully peel up the graphic to the problem area to fix.

Graphics are not meant to go through the car wash. We recommend removing them from your vehicle and applying them to a clean surface at home.

We strongly suggest that you do not apply to brick, stucco, unfinished drywall or fabrics. Although the graphics will stick to these as well as unclean surfaces, the life of the repositional adhesive will be reduced.